The operation steps of the main workflow of the burner

There are many kinds of burners, and the form of use is not the same. The use of our common burners is still somewhat similar.

The operation steps of the main working process of the burner are as follows:

The operator passes through the incinerator investigation hole to confirm whether the mother fire can ignite.

When the fire is lit and settled, press the mother fire start button on the burn control panel. After the mother fire burns properly. Said check to see if the gas supply pressure in the main line is normal.

The fan starts and enters the pre-blowing period. Check and admit that the equipment is in normal condition. Investigate gas and air pressure indications and acknowledge giving consent instructions for incinerator operation.

Press the burn control button on the burn control panel. Now the burn control enters the burn start sequence.

The burning mission of the next mother fire is over. Operators should close the mother fire button on the panel in time, block the mother fire storage fire burning.

In the process of fire burning, the operator can adjust the size of the flame at any time according to the requirements of the process. Adjust the operating handle of the gas valve and air valve, which can be adjusted during the period, and determine that the load output of the incinerator meets the process demand.

For more information about burners, please continue to pay attention to Wuxi Saiwitt Burner Manufacturing Co., LTD